Share

Sunday, October 17, 2010

How input sensor works? code P0717

How input sensor works?code P0717

Model: Hyundai Elantra

Year Model: 2010

Fuel: Gasoline

Displacement: 1600cc

 

 

Transmission  Automatic Transaxle  P0717 A/T Input speed Sensor Circuit Low Input

 

 

Study Guide and Component Location

clip_image004

Study Guide and General Description

The Study Guide input(turbine) speed sensor outputs waveform signals according to the revolutions of the input shaft ,installed in front of End clutch retainer,of the transmission. The Study Guide TCM determines the input shaft speed by calculating the frequency of the pulses. This Study Guide value is mainly used to control the optimum fluid pressure during shifting.

Study Guide and DTC Description

The Study Guide PCM/TCM sets this code if an output pulse-signal is not detected, from the input speed sensor, when the vehicle is running faster than 30 km/h. The Study Guide Fail-Safe function will be set by the PCM/TCM if this code is detected.

DTC Detecting Condition

Item Study Guide

Detecting Condition Study Guide

Possible Cause Study Guide

Study Guide and DTC Strategy

● Speed rationality check

● Signal circuit is open or short.
● Sensor power circuit is open
● Sensor ground circuit is open
● Faulty INPUT SPEED SENSOR
● Faulty PCM/TCM

Study Guide Enable Conditions

● Battery Voltage ≥ 10V
● Output speed ≥ 1000rpm
● Engine speed(Only current gear is the 1st gear) ≥ 3000rpm
● Lever position : D,3,2,L

Study Guide and Threshold Value

● Input speed = 0

Study Guide and Diagnostic Time

● More than 1sec

Fail Safe

● Locked into 3rd or 2nd gear.
● Manual shifting is possibe(2 nd → 3 rd ,3 rd → 2 nd)

Study Guide and Specification

Input shaft & Output shaft speed sensor

● Type : Hall sensor

● Current consumption : 22mA(MAX)

● sensor body and sensor connector have been unified as one.

Study Guide and Schematic Diagram

Study Guide and Signal Waveform

clip_image005

more case and study guide

0 comments:

Post a Comment